Whirlpool W11 CM145 Instructions For Use Manual page 29

DISPLAYED MESSAGE
SELECT A MILDER TASTE OR
REDUCE PRE-GROUND COFFEE
QUANTITY
INSERT WATER SPOUT
INSERT MILK CONTAINER
INSERT INFUSER ASSEMBLY
WATER CIRCUIT EMPTY
PRESS OK TO START FILLING
PROCESS
POSSIBLE CAUSE
Too much coffee has been used.
The hot water spout (C4) is not inserted or
is inserted incorrectly
The milk container (D) is not inserted
correctly.
The infuser (A5) has not been replaced
after cleaning.
The water circuit is empty
REMEDY
Select a milder taste by pressing
reduce the quantity of pre-ground coffee (maximum
1 measure).
Insert the water spout as far as it will go.
Insert the milk container as far as it will go (fig. 19).
Insert the infuser as described in section "Cleaning
the infuser".
Press
(C4) until it flows out normally. Delivery stops
automatically.
If the problem persists, make sure the water tank
(A12) is fully inserted.
29
AROMA (B6) or
to deliver water from the spout
EN