Setting-Event-Event; Creating An Event - Honeywell 30 Series User Manual

Setting-Event-Event

The events reported from individual cameras' alarm in /alarm out, and motion detection can
be accommodated in the NVR system's alarm settings. These events will then be reported or
trigger corresponding actions as follows:
•
Record the video by the time the event is triggered.
•
Reporting events via Email with snapshots attached.
•
Sound the onboard buzzer.
•
Triggering video snapshot and text message by the occurrences of events to an FTP site.
•
Triggering a camera's alarm out.
•
Triggering a PTZ camera(s) for its lens to move to a preset position.
•
Sending notification to the HVMV for MS Window software.
•
Sending a full screen live view on the connected monitor.
When an alarm is triggered, a message prompt will appear on the Liveview or any
configuration window.
Figure 6-18 Event

Creating an Event

Go to

1. Click
Figure 6-19 Create a New Event-Status
2. Manually enter a name. Up to 16 numeric or alphabetic characters is supported for the
name, including symbols such as [0-9] [a-z] [A-Z] [_] []. And then designate the interval
Event.
and the following window is displayed:
Settings
41