At+Cwsap_Cur - Current Config Of Softap Mode - Espressif Systems ESP8266 At Instruction Set

Espressif Systems
! !
10. AT+CWSAP_CUR – Current config of softAP mode
AT+CWSAP_CUR – Set configuration of softAP mode, won't save to Flash
Example
AT+CWSAP_CUR="ESP8266","1234567890",5,3
Command AT+CWSAP_CUR?
Response +CWSAP_CUR:<ssid>,<pwd>,<chl>,<ecn>
<ssid>
<pwd>
<chl>
Parameters < ecn
< ecn
< ecn
< ecn
Command
AT+CWSAP_CUR=<ssid>,<pwd>,<chl>,<ecn>
OK
Response
ERROR
Parameters
The same as above.
This command is only available when softAP mode enable.
Notes
ESP8266 softAP don't support WEP.
This configuration will
Espressif Systems Confidential
!
string, ESP8266 softAP' SSID
string, range: 8 ~ 64 bytes ASCII
channel id
>0 OPEN
>2 WPA_PSK
>3 WPA2_PSK
>4 WPA_WPA2_PSK
25 54
not store in Flash.
/
ESP8266
AT Instruction Set
Friday, May 22, 2015