Erreka PUMA-I Quick Installation And Programming Manual

PUMA-I
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The installation manual can be downloaded by going
WARNING
to the "Downloads" section of Erreka website:
http://www.erreka-automation.com
Assembly levels (mm)
Elements of the complete installation
Unlocking
2
Unlocking for manual
operation:
• Insert the key (1) and
turn clockwise without
forcing it.
• Turn the handle (2)
E268C
clockwise
through to the stopper
but without forcing it.
E268D
Unlocking
D268A
Locking for operation
• Turn the handle (2) anti-clockwise 270°
without forcing it.
• Turn the key (1) anti-clockwise and remove.
• Push the cylinder (3) inward and manually
270°,
move the gate to interlock it in the operator
mechanism
English
Electrical wiring
A: Main power supply
B/E: Flashing light/Antenna
C: Photocells (Tx / Rx)
D: Pushbutton/wall key
WARNING: The PUMA-I
operator is supplied
without a capacitor for the
motor, since the control
b o a r d ' s I n v e r t e r
technology makes it
unnecessary. If this board
is used to replace another
operator, do not use a
capacitor for the motor.
Locking
2
3
D268B
motorised:
9