Subaru BRZ 2017 Owner's Manual page 155

■
Engine speed while driving (vehicles with an automatic transmission)
In the following conditions, the engine speed may become high while driving.
This is due to automatic up-shifting control or down-shifting implementation
to meet driving conditions. It does not indicate sudden acceleration.
●
The vehicle is judged to be driving uphill or downhill
● When the accelerator pedal is released
●
When driving on curves
●
When the brake pedal is firmly depressed
■
New vehicle break-in driving (the first 1600 km [1000 miles])
The performance and long life of your vehicle are dependent on how you
handle and care for your vehicle while it is new. Follow these instructions
during the first 1600 km (1000 miles):
●
Do not allow the engine speed to exceed 4000 rpm except in an emer-
gency.
●
Do not drive at one constant engine or vehicle speed for a long time,
either fast or slow.
●
Avoid starting suddenly and rapid acceleration, except in an emergency.
●
Avoid hard braking, except in an emergency.
The same break-in procedures should be applied to an overhauled
engine, newly mounted engine or when brake pads or brake linings are
replaced with new ones.
■
Replacement of brake pad and lining
The front disc brake and the rear disc brake have audible wear indicators on
the brake pads. If the brake pads wear close to their service limit, the wear
indicator makes a very audible scraping noise when the brake pedal is
applied.
If you hear this scraping noise each time
you apply the brake pedal, have the
brake pads serviced by your SUBARU
dealer as soon as possible.
2-1. Driving procedures
155
2