Installation - BOMANN VS 7316 Instruction Manual Instruction Manual

Delivery scope Delivery scope
Delivery scope Delivery scope
5x glass shelf, 1x vegetable box, 1x egg tray,
1x door handle incl. fixing screws with covers,
(reversing the door opening)
1x hinge cover

Installation

Installation
Installation Installation
Conditions for the installation location Conditions for the install Conditions for the install Conditions for the install
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 5 cm and to the side
-
walls each approx. 10 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to the "EU Product Data Sheet" or to the rating la-
bel located in the interior or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the Avoid the Avoid the installation: Avoid the installation: installation: installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
ation location ation location ation location
Assembling the door Assemb ling the door handle
Assemb Assemb ling the door ling the door
Remove the cover caps from the door outer side and
tighten the handle with the delivered screws into the
underlying holes. Put the included screw covers on.
Electrical c c c c onnection Electrical onnection
Electrical Electrical onnection onnection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock shock!
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening Reversing the door opening
Reversing the door opening Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE
NOTE NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
18
handle
handle handle
electric
electric electric
screw wrench, Phillips screw-