Drive DeVilbiss 123S User Instructions

Introduction

The Drive DeVilbiss Bed Support Rail is height
adjustable and robust. The support base slides
between the mattress and the bed frame. The
vertical bar rests against the mattress edge to
provide a side supporting hand rail.
It includes an adjustable strap which can be used
fasten the rail to the bed if required.

Assembly - Bed Support

a. Pull the 'E' clips (2) out of the Support Rail
(3).
b. Slide the Support Rail (3) in to the holes in
the Base (1).
c. Reinsert the 'E' clips (2) in to the Support
Rail.
d. If required, attach the strap to the base (4).
Then secure the base to bed base,
following the instructions (right).
e. Adjust the handle height (see overleaf) to
suit the user and mattress.
1
3
2
Support Rail with Strap
User Instructions

Assembly - Bed Support Strap

a. Remove the mattress from the bed.
b. Place the bed support on the bed base
in the required position.
C. Adjust the strap to its longest position
and wrap the strap around the
underside of the bed base. Continue to
wrap the strap over the top of the bed
base, ensuring the strap goes over the
top of the bed support also.
D. Lock the two ends of the strap together
and shorten the strap so that it is taut.
E. Place the mattress back on top of the
bed and check so see that the bed
support is secure.

Cleaning

The Support Rail can be cleaned down with a
damp cloth using mild detergent and/or
disinfectant. For example, a mild chloride
disinfectant (solution of 1000 parts per million)
can be used. Excess water should be removed
using a towel and the components then
allowed to fully dry in a suitable environment.
The straps should be removed and hand
washed.
Ref: 123S