Table of Contents
Advertisement
OSD Instruction
6.White Balance (White Bal.)
- Adjust the picture color with this feature.
- Select "White Bal." by using Joystick S/W with Up / Down Direction.
- Press " Set Button" to enter "White Bal. " Select one of the following 4 modes for your
purpose.
- ATW
: Select this when the color temperature is between 1700ºK and 11000°K.
- COL-ROLL : Select this when the color rolling is occurred.
- AWC →SET: To find the optimal setting for the current luminance environment in
this mode. Set the point the camera towards a sheet of white paper
and press the SET Button If the environment changes readjust it
and press the SET Button. If the environment changes, readjust it.
- Manual
: Select this to fine-tune white balance manually. Set White Balance first by
using ATW or AWC mode. After that switch to Manual mode, fine-tune
the White Balance and the press "Set Button".
Also you can set the color temp. between Indoor and Outdoor mode
√ Remark
- White Balance may not work properly under the following conditions. In this
case, select AWC mode.
1. When the color temperature of environment surrounding the subject is out of the
control range (e.g. Clear Sky or Sunset)
2. When the ambient illumination of the subject is dim.
3. If the camera is directed towards a fluorescent light or is installed in a place where
ill
illumination changes dramatically, the White Balance operation may become
i
ti
h
unstable.
d
ti
ll
th Whit B l
11
SUPER HIGH RESOLUTION WDR CAMERA
ti
b
Advertisement
Table of Contents
