Lawn-Boy 22270 Operator's Manual page 7

1. Higher handle position
Note: Torque all bolts to 120 in-lb (13.6 N·m).
2. Remove the two screws that hold the back cover in
place and remove the back cover (Figure 5).
3. Route the blade brake cable around the outside of
the handle and attach the cable end (Figure 6).
Figure 4
2. Lower handle position
Figure 5
1. Blade brake cable
2. Insert cable jacket end
here
4. Ensure that the blade control bar is properly
adjusted. Refer to Adjusting the Blade Control in
the Maintenance section.
5. Route the self-propel drive cable around the outside
of the handle, thread the cable through the opening
on the left hand side of the housing, and attach the
cable end (Figure 7).
1. Self-propel drive cable
2. Insert cable jacket end
here
6. Ensure that the self-propel drive is properly adjusted.
Refer to Adjusting the Self-propel Drive in the
Maintenance section.
7. Route the throttle cable around the outside of the
handle, insert the cable jacket in the cable clamp,
7
Figure 6
3. Attach cable Z-fitting end
here
4. Throttle cable
Figure 7
3. Attach cable end here