RELM RM Series Field Programming Manual page 9

2.1.1.2 Dealer Mode – Channel Settings
To place the unit into the "Dealer Mode" for editing the global settings, do the following:
5. Switch the unit "off".
6. While pressing and holding the [C] key, switch the power "on". The radio enters the
dealer mode and "COMMON" appears on the display.
7. Press the [▲] or [▼] key to enter the "Channel" menu. Pressing the [▲] will start at the
first programmed channel and pressing the [▼] will start at the last programmed
channel.
8. While in the channel menu, press the [A] key scroll forward through the menu items or
press the [B] key to scroll backwards through the menu items.
Table 2.3 shows the channel settings that can be selected while in this mode. While in this
mode, use the [▲] and [▼] keys to view the options for the channel setting. To save the setting,
press [A] or [B] before exiting Dealer Mode. When finished programming, cycle the power of
the unit to exit "dealer" mode and start "user" mode.
Function Function
No. Name
2.5 kHz (250) , 5.0 kHz
(500), 6.25 kHz (625),
7.5 kHz (750), 10 kHz
1 RX Channel
(1000), 12.5 kHz
Steps
(1200), 15 kHz (1500),
20 kHz (2000), 25 kHz
(2500)
RX Frequencies from 136
2
Frequency – 148 MHz
RX Tone CTCSS Tones from
3 (Decode
67.0 Hz to 254.1 Hz
Signal)
and CDCSS codes
from 023 to 754.
2.5 kHz (250) , 5.0 kHz
(500), 6.25 kHz (625),
7.5 kHz (750), 10 kHz
TX Channel
4 (1000), 12.5 kHz
Steps
(1200), 15 kHz (1500),
20 kHz (2000), 25 kHz
(2500)
TX Frequencies from 136
5
Frequency – 148 MHz
Page 8
Option
(Factory defaults are
Left
highlighted) Char. Char.
RSTP 500
R 1XXxxxx
DSIG OFF
DSIG 0670
DSIG 754
TSTP 500
T 1XXxxxx
Display
Right
Sets the channel increment size for editing the
frequency while in dealer mode.
Pressing the [D] key will toggle between edit mode
of the most significant digits (XX), the edit mode of
least significant digits (xxxx), and exiting the edit
mode. When the digits are flashing (edit mode),
use the [▲] or [▼] key to change the frequency.
When the least significant digits (xxxx) are
flashing, the increment change is determined by
what is set in "RX Channel Steps".
No Tone.
Pressing the [▲] will start scrolling through the
CTCSS frequencies as listed in Table 2.7 and then
~
it will continue through the CDCSS codes as listed
in Table 2.8.
Sets the channel increment size for editing the
frequency while in dealer mode.
Pressing the [D] key will toggle between edit mode
of the most significant digits (XX), the edit mode of
least significant digits (xxxx), and exiting the edit
mode. When the digits are flashing (edit mode),
use the [▲] or [▼] key to change the frequency.
When the least significant digits are flashing, the
increment change is determined by what is set in
"TX Channel Steps".
Remarks
RELM Communications