RELM RM Series Field Programming Manual page 8

Function Function
No. Name
Call 1
Call 2
Call 3
Call 4
Redial
Trap
Hook Alert
Two-Tone
External/Internal Mic
Back Light
DTMF Off
5
Speaker On
User Tone CTCSS Tones from
6
1 67.0 Hz to 254.1 Hz
User Tone CTCSS Tones from
7
2 67.0 Hz to 254.1 Hz
User Tone CTCSS Tones from
8
3 67.0 Hz to 254.1 Hz
Back Light Key
9 with any
On
Key
Off
Back Light
0s ~ 10s
10
Timer
(1s steps)
Default
Off, 0s ~ 60s
11 Display
(10s steps)
Time
Off
Start-up
12
Display
On
DTMV 0 ~ 3, 1 incremental
13
Volume steps
Mic. 1 ~ 8, 1 incremental
14
Volume steps
Speaker 0 ~ 3, 1 incremental
15
Volume steps
Beep 0 ~ 3, 1 incremental
16
Volume steps
Back-up
17
State
Table 2.2 – Dealer Mode Global Settings
RELM Communications
Option
(Factory defaults are
Left
Char. Char.
highlighted)
PKYxCAL1
PKYxCAL2
PKYxCAL3
PKYxCAL4
PKYxRDAL
PKYATRAP
PKYAHKHA
PKYA2TON
PKYA MIC
PKYABKLT
DTMF OFF
DTMF
CT1
CT1
CT1
BKLT KEY
BKLT
BKLT OFF
BLTM
BLTM
BLTM
DFTM OFF
DFTM
DFTM
STDP OFF
STDP ON
DTVL
DTVL
MCVL
MCVL
MCVL
SPVL
SPVL
SPVL
SPVL
Display
Right
When selected, it will send the preprogrammed
DTMF Signal.
When selected, it will send the preprogrammed
DTMF Signal.
When selected, it will send the preprogrammed
DTMF Signal.
When selected, it will send the preprogrammed
DTMF Signal.
When selected, resends the DTMF tones.
When selected, it suspends the operation of the
radio until the power is re-cycled.
When selected, it toggles the "Hook Alert" feature
"on" or "off".
When selected, it sends the 2-Tone sequence that
has been set for that channel.
When selected, it toggles between the TX audio
being routed through the front microphone jack or
through the real accessory connector.
When selected, it toggles the back light "on" or
"off".
DTMF tones are not heard through the speaker.
ON DTMF tones are heard through the speaker.
xxxx
xxxx
xxxx
Any key pressed will turn the back light "on" for the
duration of the "back light timer" setting.
ON Back light is always "on".
Back light is always "off".
0
3 The duration that the back light is "on".
10
"Default display" will not appear.
10 The "default" display will appear after the "default
display time" has passed.
60
The "start-up display" label will not be displayed.
The "start-up display" label will appear during boot-
up and remain on until the channel is changed, a
function button is pressed, or scan mode is active.
0 Sets the DTMF Volume level. The higher the
number, the higher the level.
3
0
3
8
0
3
0
Sets the beep volume level. The higher the
number, the higher the level.
3
Remarks
Page 7