Related Manuals for RELM RP3600 Series
Summary of Contents for RELM RP3600 Series
- Page 1 Preliminary RP3600 Series Field Programming Manual P/N FLDPRGMANRP36 Ref. # 0301-309XX-XXX Rev. 06-05...
-
Page 3: General Information
174MHz for VHF and 440 MHz to 175MHz for UHF. The radios are multi-channel and digitally synthesized using a single TCXO for frequency control. The RP3600 series incorporate an EEPROM for the storage of channel frequency, CTCSS Tone, DCS Code, Two-Tone, and Dual Tone Multiple Frequency/Automatic Numeric Identifier (DTMF/ANI) encode information. -
Page 4: Programming Mode
Press the【◄】or【►】keys to scroll through the setting menu. ② Entering a name or alias Refer to the respective appendix for character data input. ③ Entering a number Enter the digits through the numeric keys. The cursor automatically moves to the last digit RELM Communications Page 2... - Page 5 Signaling Set 2-tone/ 5-tone settings System set System set System settings, language, zone Prompt tone Prompt Tone Tone frequency settings Record set Record Set Record settings TOT rekey time, TOT reset time, TOT pre- alert time RELM Communications Page 3...
-
Page 6: Appendix 1 Channel Set
The submenus are shown as the following appendixes. Changes may occur in the submenus as a result of the software upgrading. Please refer to the radio LCD display during your menu operation. Follow the programming software to make settings. Appendix 1 Channel Set RELM Communications Page 4... - Page 7 Appendix 2 Scan Set RELM Communications Page 5...
-
Page 8: Appendix 3 Key Assignment
Appendix 3 Key Assignment RELM Communications Page 6... - Page 9 Appendix 4 ANI Set RELM Communications Page 7...
-
Page 10: Appendix 5 Selective Signaling
Appendix 5 Selective Signaling RELM Communications Page 8... -
Page 11: Appendix 6 2-Tone Signaling
Appendix 6 2-Tone Signaling (1) RELM Communications Page 9... - Page 12 Appendix 7 2-Tone Signaling (2) RELM Communications Page 10...
-
Page 13: Appendix 9 System Set
Appendix 8 5-Tone Signaling Appendix 9 System Set RELM Communications Page 11... - Page 14 RELM Communications Page 12...
- Page 15 Appendix 10 TOT, Prompt Tone and Record Set RELM Communications Page 13...
- Page 16 Wire Clone…. Wire Clone Clone End Ch 1 When data cloning is completed and another radio needs to be cloned, change out the target radio and press the PTT button again to start another cycle of cloning. RELM Communications Page 14...
- Page 17 LED indicator on the target radio will glow green. When data is ” appears on both displays being transferred to the target radio, status bars “▐▐▐▐▐▐▐▐ and a beep sound will be heard from the target radio. RELM Communications Page 15...
- Page 18 Target Radio Wireless Cloning Receiving Data ▐▐▐▐▐▐▐▐ ▐▐▐▐▐▐▐▐ Clone End Clone End 8) When data cloning is completed and another radio needs to be cloned, change out the target radio and perform steps 4 – 7. RELM Communications Page 16...
- Page 19 RELM Wireless Corporation 7100 Technology Drive West Melbourne, FL 32904 (800) 422-6281 (321) 953-7986 service@RELM.com RELM Communications Page 17...