Table of Contents
Advertisement
INSTALLING
YOUR FURNACE
Front Panel Installation
Place the front panel top over the channel on the header plate,
as shown in Figure 16. Press the panel tight against wall, and
secure it to the header channel with the screw provided in final
assembly package. Open the control door at bottom of panel
and fasten the panel at each side through slots in flanges with
screws provided.
Attach handle to the front panel door with the screw provided.
Install the second face panel in same manner for 500 Series
models.
FIGURE 16 – Panel Placement
18
Thermostat Installation
Use the thermostat supplied with the unit.
1.
Use cable supplied with the unit.
2.
If a new location is chosen or if this is a new installation,
thermostat cable must first be run to the location
selected. These instructions cover bringing the cable
down from the attic but it may be run from a basement
or crawl space using similar methods.
3.
Before drilling a hole in the wall at the selected location,
drive a small finish nail through the ceiling in the corner
of the wall and ceiling above the thermostat location. Pull
the nail out and push a small, stiff wire through the hole
so it can be found in the attic. Drill a ½-inch hole through
the ceiling wall plate.
4.
Probe for obstructions in the partition. Then, drill a
½-inch to 1-inch hole through the wall at the selected
location for the thermostat.
5.
From the attic, feed the thermostat cable through the
wall until even with the thermostat location.
6.
Snag the thermostat cable through the hole and pull the
cable through the hole in the wall so that 6-inches of the
cable protrude.
7.
Route cable to the furnace.
8.
Never use nails or staples across the thermostat cable.
Wall-mounted thermostat installation
1.
Mount thermostat mounting plate on wall making sure the
opening on the plate matches up with the hole in the wall
were the thermostat cable will be threaded through.
2.
Thread thermostat cable through the hole in the wall and
mounting plate.
3.
Connect thermostat cable to thermostat.
4.
Mount thermostat onto mounting plate.
IMPORTANT: Keep the thermostat cable away from the combustion
chamber.
FIGURE 17 – Thermostat Settings
Date
Settings
Mode
Time
Access Settings/Back
Room Temperature
BTU Output Level
Set Temperature
Increase Set Temp/Scroll Up
Confirm/Select
Decrease Set Temp/Scroll Down
Hide quick links:
Advertisement
Table of Contents
