Installing Pcie-Poe312M - Neousys Technology PCIe-PoE312M User Manual

4.3

Installing PCIe-PoE312M

PCIe-PoE312M utilizes the x4 PCI Express bus to communicate with the host computer.
Before you install the PCIe-PoE312M, please make sure that there is a x4 PCI Express slot
available on your host computer.
NOTE
Most modern computers have x16 PCI Express slot(s) for installing a graphics card.
It can be possibly configured as a PCI Express Root Port for installing a general PCI
Express card. Please contact the vendor of your computer to check if
PCIe-PoE312M can be fitted into your x16 PCI Express slot.
Please refer to you system's instruction or user manual on accessing the PCI
Express slot for installation.
You can install the PCIe-PoE312M frame grabber card by following the steps listed below.
1. Configure Board ID if necessary according to section 4.1.
2. Configure 12 VDC source if necessary according to section 4.2. If the power source is set
to draw power from the 4-pin molex connector, please make sure it is connected.
3. Open the chassis of the host computer and expose the x4 PCI Express slot (or a
compatible x16 PCI Express slot).
PCIe-PoE312M
16