Configure Board Id For Pcie-Poe312M - Neousys Technology PCIe-PoE312M User Manual

4.1

Configure Board ID for PCIe-PoE312M

You can install multiple PCIe-PoE312M cards to your system and the card offers manual
per-port power on/ off control. The on/ off control acts as a function that allows you to manually
reset connected PoE+ PD devices via Neousys' API. To support per-port on/ off control for
multiple cards, you must set board IDs for each PCIe-PoE312M installed. The PCIe-PoE312M
incorporates a DIP switch to configure user-defined board ID. The board ID can be used as a
parameter in API to specify a PCIe-PoE312M card.
The DIP switch is located on the upper-left corner of PCB. P1 ~ P3 of DIP switch are used to
specify the board ID.
You can configure the board ID by set the position of P1 ~ P3 according to the following table.
Board ID DIP switch position
0
1
2
3
PCIe-PoE312M
Board ID
4
5
6
7
14
DIP switch position