Table of Contents
Advertisement
Use Your 2 in 1 Fan Heater
Heating Mode Selection
Press
button to set the mode, the mode is changed in sequence:
Low Power, High Power Heating Mode.
a) Low Heating Power: LED
b) High Heating Power: LED
Cauti
n
o
: : If the room temperature is higher than the temperature setting, PTC heating
C AUTION
elements and mode indicator on the panel will stop automatically while fan will operate
for another 10 seconds before it stops. When the room temperature is below the
temperature setting 1℃, PTC heating elements restart and heating mode will show on the
display panel. The machine continues to work. This is not malfunction.
Fan Mode Selection
Press
button to set the mode, the mode is changed in sequence:
Low Power, High Power Fan Mode.
a) Low Fan Power: LED
b) High Fan Power: LED
Auto Swing
Press
button to start/stop the "Swing" function.
a) On: Press
button, LED
b) Off: Press
button again, LED
Timer
Press
button to set the "Timer" function.
a) Timer function: Press
timer with a range of 0 to 12 hours. Press "
press "
" button once to lower time setting by 1 hour, hold the "
the number rapidly.
b) Previous timer setting will not change when enter to setting mode unless you press "
button to reset the time, and press
c) If you don't set the time in 5 seconds or you press other buttons except "
panel will exit the Timer function and will show room temperature immediately.
10
lights up.
lights up.
lights up.
lights up.
light up.
off.
button and LED
lights up. You can press "
button to confirm the changes.
" button once to raise time setting by 1 hour,
" button to set the
" button to change
", the display
"
Advertisement
Table of Contents
