Replacing Needles; Replacing Led Lighting - Baby Lock Euphoria BLC4 Instruction And Reference Manual

Replacing Needles

M
A
I
N
T
E
N
A
N
C
E

Replacing LED Lighting

Your Baby Lock Euphoria is equipped with a long-life LED lighting system. It is not necessary to
change bulbs.
If LED unit requires replacement, please contact your authorized Baby Lock retailer.
41
Needle Identification (fig. A)-
The chain/cover stitch needles are identified by C-1,C-2 and C-3
on the front of the needle clamp (fig. A).
C-1-Left chain/cover stitch needle can be used for chain stitch, left
narrow cover stitch, wide cover stitch or triple cover stitch.
A
C-2-Center chain/cover stitch needle can be used for a chain
stitch, left narrow cover stitch, right narrow cover stitch or
triple cover stitch.
C-3-Right chain/cover stitch needle can be used for a chain stitch,
right narrow cover stitch, wide cover stitch, or triple cover
stitch.
To Replace a Needle -
1. Raise the needle to the highest position by turning the
handwheel toward you.
2. Using the allen screwdriver, loosen the needle screw for the
needle to be changed. Screws are located by sequence as
B
indicated above.
Note: To prevent the needle from falling into the needle plate, hold
it with the needle insert tool as you loosen the screw (fig. B).
3. Use the needle insert tool or tweezers to insert the new needle
with the flat side to the back. Insert needle as far as it will go,
check the needle viewing window (fig. C).
Note: Do not tighten needle clamp screw(s) without needle being
inserted within the slot.
Note: If you do drop a needle down into the machine, just pull
out the needle-drop drawer at the bottom of your machine.
The needle will be on the drawer (fig. D).
C
D