Setting Up Your Euphoria - Baby Lock Euphoria BLC4 Instruction And Reference Manual

Setting Up Your Euphoria

O
V
E
R
V
I
E
W
9
1. Remove machine from box
After removing the packing materials from the
box, gently lift your Baby Lock by grasping the
handle provided on the top of the machine.
Place the machine on a sewing table or any
level surface that provides ample work area to
the left. Place the foot controller in a pedal
stay, if desired, and place it under the sewing
table.
2. Plug in the machine
Plug the power cord into the machine first, then
A
into a wall outlet. The power switch is located
toward the back on the right side of the
machine. Always make sure the power is off
when the machine is not in use (fig. A).
Available foot controller for U.S.A. and
Canada: Model YC-482.
Place the foot control cord along the inside of
the channel located on the bottom right side of
the machine (fig. B).
3. Polarized plug
This appliance has a polarized plug (one blade
wider than the other). To reduce the risk of
electric shock, this plug is intended to fit in a
B
polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the
plug in any way.
4. Foot controller
The sewing speed of the machine is
determined by the amount of pressure applied
to the foot controller. When not in use, do not
place anything on the foot controller, or the
machine could start inadvertently and the
controller or motor could burn out.
5. Position the telescopic thread guide
Raise the telescopic thread guide to its
highest position. Rotate the shaft to the left
C
and right until each section "clicks" into a
locked position (fig. C).