Mitsubishi Electric PEA-RP200WKA Service Manual page 44

8. Separating the unit
1. Removing the covers
(1) Remove the two fixing screws on the control box
cover to remove it.
(2) Remove the three fixing screws on the lead wire
cover to remove it.
2. Remove the external wires, and place the unit
on a level surface
3. Disconnect the thermistor connector (CN44)
from the Indoor controller board.
4. Removing the blocks
(1) Remove the four fixing screws on the two
attachment blocks to remove them.
(2) Remove the three fixing screws on the top
plate.
(3) Separate the unit.
Exercise caution when removing heavy parts.
Fig. 18
Fig. 19
42
Lead wire
cover
Control box
cover
Brackets
(one on each side)
Indoor controller board