Battery Condition Meter Codes - Pride Mobility APEX ALUMALITE Owner's Manual

NOTE: The scooter battery can be charged with
the battery box either installed on or removed
from the scooter.
To charge the battery using the off-board charger:
1. Position your scooter next to a standard
electrical outlet.
2. Be certain the scooters power is turned off.
3. Plug the off-board charger into the off-board
charger socket of the scooter's battery pack. See
figure 12.
4. Plug the off-board charger into the electrical
outlet.
5. When the battery is fully charged, unplug the off-
board charger from the electrical outlet and then
from the scooter.
WARNING!
RED when the charger is not or cannot connect to the scooter. The LED is ORANGE when the
charger is connected and charging the scooter. The LED will be GREEN when the scooter has
finished charging.
Note: The LED should always be orange when the scooter is initially plugged in. If the LED immediately
goes to GREEN, it may mean that your batteries are too discharged to allow charging or there may be an
issue with your charger – In this case, please contact your Pride Service Provider for advice.
NOTE: The battery condition meter on your scooter displays an approximate reading of battery
strength. Refer to Table 1 for battery condition meter codes.
1st LED blinking
Table 1. Battery Condition Meter Codes
The LED light colour on the charger indicates a different charger status. The LED is
LEDs
10
9
8
7
6
5
4
3
2
1
(Please note that these values are estimated)
Battery Percentage
91-100% battery remaining
81-90% battery remaining
71-80% battery remaining
61-70% battery remaining
51-60% battery remaining
41-50% battery remaining
31-40% battery remaining
21-30% battery remaining
11-20% battery remaining
<10% battery remaining
<5% battery remaining
14