Table of Contents
Advertisement
3-6
Changing from InfiniBand to Ethernet Mode
AOC-MIBE6-m1C(M) is by default set to InfiniBand mode. To change the setting to
Ethernet mode, please follow the instructions below.
1. Double-check and make sure that the add-on card is detected. Run the Ispci
command:
[root@localhost ~]# lspci |grep Mellanox
61:00.0 Infiniband controller:
MT28908 Family [ConnectX-6]
2. If the setting remains unchanged, start MST:
[root@localhost ~]# mst start
Starting MST (Mellanox Software Tools) driver set
Loading MST PCI module - Success
[warn] MST PCI configuration module - Success
Create devices
Unloading MST PCI module (unused) - Success
Mellanox
3-7
Chapter 3: Installation
Technologies
Advertisement
Table of Contents
