Fujitsu ETERNUS AX Series Installation And Cabling Manual page 9

6. If as part of system set up and configuration, you did not enable disk ownership automatic assignment,
manually assign disk ownership; otherwise, go to the next step:
a) Display all unowned disks:storage disk show -container-type unassigned
b) Assign each disk:storage disk assign -disk disk_name -owner owner_name
You can use the wildcard character to assign more than one disk at once.
7. Download and run Config Advisor as instructed by the "Installation and Setup Instructions" to verify SAS
connections are cabled correctly and there are no duplicate shelf IDs within the system.
If any SAS cabling or duplicate shelf ID errors are generated, follow the corrective actions provided.
Fujitsu Downloads: Config Advisor
You can also run the storage shelf show -fields shelf-id command to see a list of shelf IDs
already in use (and duplicates if present) in your system.
8. Verify that in-band ACP was automatically enabled. storage shelf acp show
In the output, "in-band" is listed as "active" for each node.
| Installing and cabling disk shelves with IOM12 modules for a new system installation |
9