Cabling Disk Shelves With Iom12 Modules For A New System Installation - Fujitsu ETERNUS AX Series Installation And Cabling Manual

Table 1:
1 Raised button on the right side of the drive carrier
e) Lower the drive straight down, and then rotate the cam handle down until the drive snaps into place
under the orange release latch.
f) Repeat the previous substeps for each drive in the drawer.
You must be sure that slots 0, 3, 6, and 9 in each drawer contain drives.
g) Carefully push the drive drawer back into the enclosure.
Table 2:
h) Close the drive drawer by pushing both levers towards the center.
i) Repeat these steps for each drawer in the disk shelf.
4. If you are adding multiple disk shelves, repeat this procedure for each disk shelf you are installing.
Note: Do not power on the disk shelves at this time.

Cabling disk shelves with IOM12 modules for a new system installation

You cable disk shelf SAS connections—shelf-to-shelf (as applicable) and controller-to-shelf—to establish storage
connectivity for the system.
Before you begin
You must have met the requirements in the "Requirements for installing and cabling disk shelves with IOM12
modules for a new system installation" section and installed the disk shelves in the rack.
About this task
After you cable the disk shelves, you power them on, set the shelf IDs, and complete system setup and
configuration.
| Installing and cabling disk shelves with IOM12 modules for a new system installation |
Attention: Possible loss of data access
– Never slam the drawer shut. Push the
drawer in slowly to avoid jarring the drawer
and causing damage to the storage array.
6