Vertiv Remote Access Key Quick Installation Manual
Vertiv Remote Access Key Quick Installation Manual

Vertiv Remote Access Key Quick Installation Manual

Advertisement

Remote Access Key
Quick Installation Guide
NOTE: You will need to configure the
Avocent® AutoView™ switch for Dell
network settings at the local Setup port
for KVM remote access to function.
1.
Connecting the Remote
Access Key
Connect the Remote Access Key
to any USB port on the AutoView™
switch for Dell. When the key
receives USB power, the LED on
the key will blink slowly, followed
by rapid blinking to indicate
successful enumeration, and then
illuminate continuously when the
key is accepted.
Dell Remote Access Key
1
590-1525-501A
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Remote Access Key and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vertiv Remote Access Key

  • Page 1 Setup port for KVM remote access to function. Connecting the Remote Access Key Connect the Remote Access Key to any USB port on the AutoView™ switch for Dell. When the key receives USB power, the LED on...
  • Page 2 | Vertiv Headquarters, 1050 Dearborn Drive, Columbus, OH, 43085, USA © 2017 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names, trademarks or registered trademarks of their respective owners.

Table of Contents