Rear Panel Section - Vestax PMC-07ProISP Owner's Manual

REAR PANEL SECTION

SERIAL NO.
MADE IN JAPAN POWER
AC 12V
29 30
@9 POWER SWITCH
Power for mixer, on status indicated by
POWER LED(!6 ) on top panel; should be
turned on after all connections are made.
Note
As a general rule for protection, the amp should
be turned on last and turned off first.
#0 AC POWER JACK
Connect AC ADAPTOR (AC-12A) in here
before switching on power.
Note
UNAUTHORIZED POWER ADAPTORS MAY
CAUSE HARM TO UNIT.
#1 MASTER OUT JACK-FRONT [1/4 inch TRS balanced]
Main output jacks for front left and front right
speaker zones. Connect to power amp or
crossover.
#2 MASTER OUT JACK-REAR [1/4 inch TRS balanced]
Main output jacks for rear left and rear right
speaker zones. Connect to power amp or
crossover.
Note
These connectors are Tip=hot, Ring=cold,
Sleeve=ground.
HOT COLD
fig.C T.R.S JACK
31
PMC-07ProISP
PROFESSIONAL QUADRAPHONIC DJ MIXER
MASTER SUB MASTER
R L R
32
GND
33 35
WARNING;SHOCK HAZARD-DO NOT OPEN.
AVIS;RISQUE DE CHOC ELELCTRIQUE -NE PAS OUVRIR.
SESSION IN
L R L
34 36
#3 SUB MASTER OUT JACK-FRONT [1/4 inch PHONE JACK unbalance]
Sub output jack for front left and front right
speaker zone. Unbalanced connectors at
-4dBm for monitoring etc.
#4 SUB MASTER OUT JACK-REAR [1/4 inch PHONE JACK unbalance]
Sub output jack for rear left and rear right
speaker zone. Unbalanced connectors at
-4dBm for monitoring etc.
#5 SESSION IN JACK-FRONT [1/4 inch PHONE JACK]
Allows front 1/4 inch chain connection with
multiple PMC-07ProISP mixers.
#6 SESSION IN JACK-REAR [ 1/4 inch PHONE JACK ]
Allows rear 1/4 inch chain connection with
multiple PMC-07ProISP mixers.
Note
See "CHAIN CONNECTION DIAGRAM" of page 10.
#7 AUX SEND JACK [1/4 inch PHONE JACK ]
Connect to the input of external effects. (delay,
reverb etc.)
#8 AUX RETURN JACK [1/4 inch PHONE JACK]
Connect to the output of external effects .
(delay, reverb etc.)
#9 PHONO INPUT JACK [ RCA JACK ]
This input for turntables with MM cartridges
only.
$0 GROUND(GND) TERMINAL
The grounding lugs for turntables. Ground for
phono circuit necessary to avoid hum.
7
37 39
C A U T I O N
RISK OF ELECTRIC
SHOCK. DO NOT OPEN
AUX SEND PHONO IN
R L
R
AUX RTN
40
38
1
2
L
GND