Establishing The Wi-Fi Connection Via Wps; Establishing The Wifi Connection Via The Silvercrest Smart-Audio App; Setting Up A Device - Silvercrest SMRB 40 A1 Operating Instructions And Safety Instructions

SilverCrest SMRB 40 A1
establishing the connection for the first time, make sure to place the sound bar (A) as close as
possible to the router to achieve an optimum Wi-Fi signal transmission. Then install the sound bar
(A) within the Wi-Fi signal range.
Please note that a maximum of 16 multi-room devices can be connected to a network. Furthermore
the multi-room devices and your smartphone/tablet must be connected to the same network.

Establishing the Wi-Fi connection via WPS

If your router features a WPS button, the easiest way to connect the sound bar (A) to the network is
using this button.

Place the power switch (17) in "ON" position to go to connection mode. After a brief
initialisation period (yellow and blue LEDs on simultaneously, then one LED briefly lights up
green) only the blue LED flashes slowly. If the LED does not flash, the sound bar must be
reset:
Press and hold the WPS / RESET button for approx. 15 seconds to restart the device. After a
brief initialisation period (yellow and blue LEDs on simultaneously, then one LED lights green
briefly) the blue LED flashes slowly and the device is in AP mode.

Next press the WPS button on your router and confirm the connection by briefly pressing the
WPS / RESET button (14) on the sound bar (A) back panel.
See the operating instructions for your router.
The sound bar (A) establishes a network connection. The blue LED flashes 3 times fast, followed by
a short pause.

After the connection has been established, the blue LED goes on.

Now the sound bar (A) can play audio signals from the network.

The sound bar (A) will save the connection data, so the next time you switch it on you don't
need to re-establish the connection again.

Establishing the WiFi connection via the SilverCrest Smart-Audio App

The following contains some important instructions for setting up your sound bar. A detailed, up-to-
date description of the SilverCrest Smart-Audio App with plenty of screenshots can be found online.
You can find the relevant internet links in the "QR codes" chapter on page 64.

Setting up a device

If you cannot establish a connection using WPS, you can use the SilverCrest Smart-Audio App to
connect your sound bar to the network.
Power on the device and start AP mode. The AP mode lets you configure and connect your sound
bar to the WiFi network.
When using it for the first time, the sound bar starts the AP mode automatically.
Otherwise, hold the WPS / RESET button for approx. 15 seconds to restart the
54 - English