Set-Up Location Requirements; Electrical Connection; Inserting/Changing The Remote; Control Batteries - Silvercrest 281566 Operating Instructions And Safety Instructions

Set-up location requirements

For safe and trouble-free operation of the device , the set-up location must fulfil
the following requirements:
■ Place the device on a firm, flat and level surface.
■ Do not operate the device in a hot, wet or extremely damp environment.
■ Keep a minimum distance of 30 cm to heat-emitting devices such as heaters,
ovens, etc.
■ Only operate the device in locations with adequate ventilation.

Electrical connection

■ Before you connect the device, compare the connection data (voltage and
frequency) on the mains adapter type plate with that of the intended power
source. These data must agree so that no damage is sustained by the device.
■ Make sure that the mains adapter's connection cable is not damaged and is
not laying over hot surfaces and/or sharp edges.
■ Connect the plug of the connecting cable into the connector for the power
supply on the rear of the unit and plug the mains adapter into a power
outlet. Ensure that the power cable is not stretched tightly or kinked.
■ Place the connecting cable such that no one can stumble over it.
■ Do not place the device, furniture or any other objects on the cable. Do not
kink the cable or knot it and do not connect it to other cables. Never wrap
the cable tightly around other objects otherwise the conductors inside the
cable could break and cause a malfunction.
Inserting/changing the remote control batteries
NOTE
► The supplied battery (Type CR2025) is already installed in the remote control
when delivered. Before use remove the isolation strip from the battery
compartment.
For replacement with a new battery proceed as follows:
♦ Pull the battery compartment out of the remote control by pressing the lateral
locking device and at the same time pull the battery compartment out.
♦ Remove the depleted battery and insert a new battery of the type CR2025
(button cell) into the battery compartment. Be sure to insert the battery with
the correct polarity.
♦ Slide the battery compartment back into the remote control until it locks into
place.
■ 8 │
GB SSTB 10 A1