Majestic ODSHR42 Homeowner's Installation And Operating Manual page 14

ODSHR Outdoor Woodburning Fireplace
Air Space Clearances
Combustible framing material MUST NOT pen-
etrate AIR SPACE (shaded areas)
2"
³⁄₄" Air Space
to Sides
Front View
Wall
Shield
Only noncombustible mate-
rial may be applied as facing
to the fireplace surround.
Fig. 20 Minimum clearances to combustibles.
Finish Wall
Finish the wall with material of your choice. Do not
install a combustible mantel shelf less than 12"
(305 mm) from the top of the fireplace opening. Do
not install a mantel face plate less than 6" (154 mm)
from top of fireplace opening. (Fig. 24) If a combus-
tible material is used below a flat mantel shelf, consult
your local building codes for minimum clearance from
top of fireplace opening to bottom of mantel shelf.
All joints (top, bottom and sides) where wall or deco-
rative facing material meets fireplace surround must
be completely sealed with a noncombustible material.
(Figs. 21-23)
NOTE: No side wall protection is required for fireplaces
installed at 45° to two (2) side walls (corner installa-
tion).
14
Standoff
Side View
Firestop
³⁄₄" Air Space
to Back
³⁄₄" Air Space
to Sides
0" Clearance to
Floor
Hearth Extension
FP559SHR
FP559SHR
SHR air spaces
5/12/99 djt
Finished Wall
Noncombustible
Decorative Fac-
ing
Must
be Sealed
with Noncombustible
Material
Surround
Fig. 21 Fireplace surround flush with finished wall.
Finished Wall
FP1166
surround flush
with finished wall
Noncombustible
Decorative Facing 12/20/01 djt
Must be Sealed with
Noncombustible
Material
Surround
Fig. 22 Facing on fireplace surround flush with finished wall.
CAUTION:
Do Not Place Finish-
ing Material Beyond
These Edges or Cover
Air Inlets
Fig. 23 Finishing front of fireplace.
FP1168
finishing front
12/20/01 djt
Stud
2 x 4 Header
Ledge Bracket
Side View
FP1166
Stud
2 x 4 Finished
Header
Covered Wall
Ledge Bracket
FP1167
FP1167
facing flush
with finished wall
12/20/01 djt
Screen Rail
Hearth
FP1168
20002264