Panasonic WJ-FS616 Service Manual page 8

5. Pull out the two knobs from the bracket shown below.
Then remove the bracket.
6. Set the jumper connector, located at the top left of the
board to be installed, to the position shown below.
Initial State
2 8
1 7
Jumper Connector
Board Connector
Installed State
2 8
1 7
7. Insert the board and confirm that the position is correct.
Then push it in straight.
8. After installing the boards, secure them by tightening the
screws and knobs shown above.
Note: Some settings for the VD2 signal and control data
will be necessary from the setup menu of the Video
Multiplexer.
Tally Output Setting
Allows you to use the Alarm Input Terminal as Tally
Output Terminal by changing two internal connections.
1. Disassemble the video multiplexer as described for
installing the Data Multiplex Boards on page 4.
ALM
10
9
2. Move the two connectors from the ALM side to the TLY
side as shown above.
The relation between the connector numbers and chan-
nel numbers is shown in the table below.
CH9 - CH16
CH1 - CH8
5
CN33 CN37
1 10 1
CN32 CN36
1 9 1
TLY
Alarm Input Tally Output
CN33 CN37
CN32 CN36