Panasonic WJ-FS616 Service Manual page 11

Connection with the Camera Sites
Connect the Camera Site equipment to the Camera
Input Connectors (CAMERA IN 1-16) on the rear of the
Video Multiplexer.
Note: Make sure that the cable length between the
camera site and the WJ-FS616 Video Multiplexer is
less than 1 200 m (4 000 ft) when using RG-6/U (5C
- 2V) or equivalent cables.
RS485
A B A B
G G
N N
T R
D D
Connection with the Monitors
Connect the Monitors to the Spot Output (SPOT OUT)
Connector and Multiscreen (MULTISCREEN) Connector
on the rear of the Video Multiplexer.
SPOT
OUT I N
16 15 14
CAMERA
IN
CAMERA
OUT
16 15 14
Video Multiplexer WJ-FS616
Video Multiplexer
WJ-FS616
MULTISCREEN
VIDEO S – VIDEO
Connect the Camera Site equipment to the RS485
Terminal on the rear of the Video Multiplexer, when
specified equipment is connected.
Note: If you use cables assembled from locally pro-
cured materials, it is important that only high quality,
data grade cable, suitable for RS-485 "2-wire twist-
ed pair shielded cable" is used.
Low grade cable will result in unstable operation of
the system.
AUX
Alarm
13 5 4 3
13 5 4 3
Connection with the WV-CU550A
System Controller
If the supplied 6-conductor cable assembly is used, sim-
ply plug one end of the cable into the DATA IN port of
the Video Multiplexer and the other end into DATA OUT
port on the System Controller.
If you use cables assembled from locally procured
materials, it is important that only high quality, data
grade cable, suitable for RS-485 "2-wire twisted pair
shielded cable" is used.
Low grade cable will result in unstable operation of the
system.
Video Multiplexer
WJ-FS616
DATA
OUT IN
TERM.
OFF ON
8
2 1
2 1
System Controller
WV-CU550A
DATA CONTROLLER
IN OUT
TERM
ON OFF
UNIT NO.
1-8
0