Linksys 10/100 LAN Card 10/100 User Manual page 9

9. Reconnect your PC's power, then power on your computer. Your com-
puter will automatically recognize the card and assign it a unique IRQ
("interrupt") and I/O address.
The card installation is complete. Next, you must configure your PC's
operating system to work with the EtherFast Card.
• For Windows 98 configuration instructions, turn to page 7.
• For Windows 95 configuration instructions, turn to page 16.
• For Windows 2000 configuration instructions, turn to page 24.
• For Windows NT configuration instructions, turn to page 28.
• For Novell Client & Server configuration instructions, turn to page 38.
If you are using an operating system other than
Windows 98, Windows 95, or Windows NT, you
will find the network driver installation instruc-
tions on the Driver Disk's readme.exe file.
N N o o t t e e : : If you intend to use
both 10Mbps and
100Mbps components on
your network, you will
need an autosensing hub
or switch. For more infor-
mation on autosensing
hubs or switches, go to
the Linksys website at
www.linksys.com.
6
Linksys EtherFast Series
N N o o t t e e : : Some screen shots
in the following sections
will vary depending on
which version of the
LNE100TX card you are
installing.