Linksys 10/100 LAN Card 10/100 User Manual page 66

EtherFast ® 10/100 LAN Cards
Setting Up Your EtherFast LAN Card for Wake-On-
LAN Use
1. Turn off your PC and remove the power cable
from the wall. Use the picture below to
locate where the WOL wire plugs into your EtherFast LAN Card.
2. Connect one end of the 3-pin Wake-On-LAN wire to the EtherFast LAN
Card.
3. If your EtherFast LAN card isn't plugged into your motherboard, slide it
in now.
4. Connect the loose end of the WOL wire into the WOL plug on your PC's
motherboard. (Check your motherboard's documentation for proper WOL
wire installation.)
N N o o t t e e : : The location of each
motherboard's WOL connection
will vary from PC to PC.
Consult your PC's documenta-
tion if you can't find it.
63