Linksys 10/100 LAN Card 10/100 User Manual page 67

Sending a Magic Packet
In order to use WOL you need to know the MAC address of the card you
wish to "wake". If you don't know the MAC address of the PC you are on,
turn to page 49 to learn how to run the EtherFast Card's diagnostic program.
1. Turn off the PC on which you want to test the WOL feature. Go to another
PC on the network and log in.
2. Go to an MS-DOS prompt. Run the diagnostics program (page 49). Press
Enter to begin the test.
3. When the test is complete, press F3 and select Send
an ACPI Packet.
4. Press the M key. You will be asked for the destina-
tion of the magic packet. Enter the MAC address of
the PC you want to "wake up" and press Enter.
5. Check to ensure that the PC has woken up.
Testing a Link Change WOL PC
This test will see if your PC responds to a change in the network link state by
waking up. Use a configured PC that is on an active network link.
1. Turn your PC off and disconnect it from the network either by turning off
the hub or switch or by disconnecting the network cable form the LAN
card.
2. Wait about ten seconds, then plug the cable back in or turn on the hub. The
PC should wake up.
64
Linksys EtherFast Series
N N o o t t e e : : The D D i i a a g g pro-
gram works only if
both the PC sending
the magic packet and
the PC receiving the
magic packet are
installed with
EtherFast 10/100 LAN
(version 4) cards.