Use Of Pump; Pump Motor Protection - Polygroup SUMMER WAVES SKIMMERPLUS SFS350 Owner's Manual

11. Place the Filter Cartridge and the Skimmer Strainer Basket
8
over the Volute Housing Inlet (see Fig. 2) and seals at the bottom of the canister so that the Skimmer Strainer Basket
the canister. See Fig. 4
12. Place the Lock Top on top of the Filter Pump Skimmer Canister
q
13. Push the Weir Foam into the Weir
g
NOTE: The weir can ONLY be pushed HORIZONTALLY into the grooves as shown by Arrows #1 in Fig. 4.
Be sure the weir moves freely through the opening, if not carefully trim away any obstructing
materials. Once the weir is installed correctly, flip it upright to lock it in place (see Arrow #2).
14. Fill the pool until the water level reaches between the min and max markers on the
inside of the Faceplate (see Fig. 4).
15. Adjust the return fitting diverter for proper water circulation.
360°
16. Plug in the GFCI power cord and enjoy your pool.
1. Plug the GFCI Power Cord Set
z
2. To turn on the Pump, press the RESET button of the GFCI Plug.
3. From inside the pool, check if the water flow from the Return Fitting Diverter
of water returning to the pool. If not, or if you feel a reduction in flow, clean or replace the Filter Cartridge
FILTER CARTRIDGE USE & CARE (p. 9) as well as Symptom 2 of TROUBLESHOOTING GUIDE (p. 15).
4. To turn the Pump off, press the TEST button of the GFCI Plug, and unplug it from the power outlet.
5. VERY IMPORTANT: Check and adjust the pH and chlorine levels daily. FILTER PUMP ALONE
WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONE
BY MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES. For details,
see POOL WATER CARE (p. 11).
IMPORTANT! Your filter pump is protected by a thermal switch. The switch senses the temperature of the filter pump. If it gets too hot, the switch
will stop the pump from running until it cools off. To restart the pump press the reset button on the GFCI when the filter pump has cooled down. This
is a safety device to prevent pump damage and prolong service life. If your pump is automatically turning off, it is because of high pool water
temperature and/or low water flow through the pump. If this happens you need to check the water flow and correct it if needed, as this filter pump
uses the water flow for cooling. You may also want to run the pump at night when the temperature is lower.
10
back into the Filter Pump Skimmer Canister
9
7
and under the tabs to hold it in place. Then slide the Weir
h
It is recommended to point the
return fitting diverter down and
away from the suction or water
intake for optimum pool circulation.

USE OF PUMP

to a grounded receptacle at least 15 feet (4.5m) away from the pool.

PUMP MOTOR PROTECTION

and lock it in place by turning it clockwise.
into the grooves from the inside of the pool. See Fig. 4.
h
is correct. It should feel like a solid stream
p
. For details, see
8
IMPORTANT: Do NOT connect to a timer device!
. It is important that the filter cartridge slips
7
will seat properly in its groove inside
9
29
Max. Water
Level
23
22
Min. Water
Level
9
25
FIG.4
How to use the GFCI plug
*Do not connect
to a timer device
24
Press
"RESET"
Button
To Start
Pump
Operation
30