SI Nano Duo Installation Instructions Manual
24v dc 485
Hide thumbs
Also See for Nano Duo:
- Installation instructions manual (16 pages) ,
- Installation instructions (4 pages) ,
- Installation instructions manual (12 pages)
Related Manuals for SI Nano Duo
Summary of Contents for SI Nano Duo
- Page 1 Nano Duo Installation Instructions 24v DC 485 INSTALLERS: Please leave this manual with the owner. Doc. # 400107...
- Page 3 PARTS LIST - NANO DUO - 24v DC - 485 Shades Wall Brackets (2) Please note all the Node IDs on your Shade motors. See the last page on these instructions. Terminal Block Brackets Terminal Blocks Screws Included (3 per Bracket)
- Page 4 SPACER BLOCKS AND LEVELING SHIMS (OPTIONAL) Spacer Blocks - used to clear an obstruction in the fabric path. Connect spacer blocks to shade brackets before installation. Note: Do not use more than 4 spacer blocks per bracket. Leveling Shims - used if the window frame is out of level. Connect to shade brackets before installation Note: do not use more than 2 leveling...
- Page 5 INSTALLATION - NANO DUO - 24v DC - 485 1. Terminate pre-wire with the supplied terminal block. Header + 24 VDC - 24 VDC Data + Data For 485 Only Data - Data ground 2. Install wall brackets 4 - 6 inches from the jamb using the supplied screws.
- Page 6 INSTALLATION - NANO DUO - 24v DC - 485 3. Make sure the wall bracket lever is down (may already be down). Proper position for installing Box 4. Install terminal block bracket between jamb and wall bracket on the motor side using the...
- Page 7 INSTALLATION - NANO DUO - 24v DC - 485 5. Connect the shade and pre-wire connectors, then snap into the terminal block bracket 6. Hang shade onto wall brackets and center in opening. Installation - Nano Duo - 24v DC - 485...
- Page 8 INSTALLATION - NANO DUO - 24v DC - 485 7. Use thumb to lock shade in place Installation - Nano Duo - 24v DC - 485...
- Page 9 PROGRAMMING - 485 RS485 shades are programmed using the Screen Innovations SIFI via the web interface. This programming can be done with a Windows or Mac computer either over LAN or wired directly to SIFI. The following instructions are for a Windows computer, but the steps for programming on a Mac are very similar.
-
Page 10: Troubleshooting - 485
Reterminate if necessary. SIFI is not powered. To verify the si.fi is powered look for a green LED flashing on the board, this light will either be steady on or flashing. If no light is visible make sure power is available via the bus power supply or PoE. - Page 11 NODE IDS Please keep a note of all the Node IDs on your shade motors. OR for larger shade orders, refer to your Sales Order document for the list. Room Shade 1 Shade 2 Shade 3 Shade 4 Shade 5 Shade 6 Room Shade 1...
- Page 12 Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com v. 1.0 4 March 2020...
Need help?
Do you have a question about the Nano Duo and is the answer not in the manual?
Questions and answers