Weekly Maintenance; Seasonal Maintenance - EdilKamin Simpaty Series Installation, Use And Maintenance Manual

MAINTENANCE

WEEKLY MAINTENANCE

• Clean the hearth (with a brush) after having removed the 2 smoke deviators (3).
• Jiggle the brush (*) located below the ceramic top.
• Empty the pellet hopper and clean the base with the vacuum cleaner.
• When cleaning the combustion chamber, lift the smoke caps (2) and suction the four pipes underneath (4).
N.B. To replace the smoke defl ector (3), the brush (*) must be pulled up to the fully extended position.
4
4
3
2
2
*
NOTE: After every 800 kg, "Mainten." will appear to remind the user to clean the smoke channels, which is the
user's responsibility. This message will disappear by pressing the "TURBO" button for 5 seconds. Upon rea-
ching 2000 kg of pellets, a "Mainten.-dealer" message will appear which will not disappear because the assistan-
ce of a DEALER is required. This message can be reset from the parameters menu.

SEASONAL MAINTENANCE

(implemented by the DEALER)
• Clean the stove internally and externally
• Carefully clean the heat exchange tubes
• Carefully clean and remove dirt from the combustion chamber and the relative compartment
• Clean fans, verify mechanical and clamp loosening
• Clean smoke channel (replace seals on smoke exhaust pipe)
• Clean smoke duct (see weekly cleaning)
• Clean smoke extraction fan compartment, flow sensor and check thermocouple.
• Clean, inspect and scrape any residue from the ignition resistance compartment and if necessary, replace it
• Clean/check the Synoptic Panel
• Visually inspect the electrical wires, connections and power cable
• Clean the pellet hopper and check loosening of the feed screw - gear motor assembly
• Replace the door seal
• Functionality test: load the feed screw, ignite, let it run for 10 minutes and shutdown
If the stove is used very often, it is recommended to clean the smoke channel every 3 months.
ATTENTION !!!
After implementing a normal cleaning procedure, INCORRECT coupling of the upper (A) and lower (B) com-
bustion chambers can compromise the stove's performance (fig. G).
Therefore, before igniting the stove, ensure that the combustion chambers are correctly coupled as shown in
(fig. H).
A
B
fig. H
fig. G
62