Advertisement
Sequence of Usage
ご使用手順
1. If moisture or dirt remains in the body or inner box, remove them with a dry
towel etc.
2. Insert basket in the inner box and place wet rolled towels on the basket.
＊ In the event the amount of towels put into the box is low, place them on the
basket as flat and as far apart as possible.
＊ The interior of the cabinet becomes heated from the surface. Place towels inside
the cabinet so that they do not come into contact with such surfaces.
＊ When warm towels are needed in a hurry, please use towels that have been
rolled after having been immersed in warm water.
＊ Put towels in heat resisting polyethylene wrap. If used without such wrapper,
towels are apt to drying up quickly or becoming discolored.
3. Close the door tightly.
4. Insert the power plug, and then press the power switch
＊ The LEDs of the power switch and the mode indication will light up.
＊ The product is set to heating
＊ When you change the mode, the changed mode will be memorized.
5. Press the mode change switch
＊ The mode indication LED to be lit is changed every time you press the mode
change switch.
Heating
UV lamp
(Orange) and (Blue)LEDs light
WARNING:
This appliance contains a UV emitter. Do not stare at the light source.
Post-use Instructions
1. Switch off and remove plug from electric outlet.
2. Take out remaining towels, etc. and wipe inner box clean to remove residual
moisture.
3. Empty water accumulated in the drain tray. Wash clean when considerably
stained.
4. Stains on the body should be wiped clean with a dry cloth or a tightly wrung
wet cloth.
＊ Use a neutral detergent when stains are severe. Do not use cleansers containing
abrasives or solvents such as paint thinners.
＊ The appliance shall not be cleaned with a water jet.
5. Leave the door of the cabinet open for a while for moisture to dry as a means
to prevent odors.
UV lamp
to select your desired mode.
mode
Heating
(Orange)LED lights
－9－
.
mode primarily.
mode
UV lamp
(Blue)LED lights
mode
Advertisement
