If an indication below appears
Remove the power plug once, and then switch on the power again.
If normal status cannot be recovered even after doing that, confirm the error
details and request repair.
Indication
LED (green) blinks
LED (orange) blinks
Troubleshooting
Situation
The LED of the power
switch does not light up.
It does not become
heated even after
waiting for a while.
Noises are heard
during use.
There is an
abnormal smell.
Details/Countermeasures
An error in the temperature sensor.
An error in the temperature control.
It can be assumed that heat has been generated and
the temperature has risen exceeding the normal range.
Check the installation condition.
●
Install the product by following the instructions
→
on page 8.
Details/Countermeasures
Is the power plug disconnected?
●
Is the power plug disconnected?
●
Are there any abnormal indications?
●
*Check "If an indication below appears" above.
Is the product installed in a stable and flat location?
●
Noises are heard from the fan that cools the
●
components.
Small noises can be heard during use or immediately
●
after use owing to expansion or contraction in the
surface inside the inner box, but it is not a failure.
Have you wiped off dirt and moisture attached to
●
the inside of the inner box regularly?
Have you emptied water accumulated in the drain
●
tray regularly?
-10-