LIGHT-UP DINO GRIP
Please also refer to the owner's manual that came with your bicycle.
Due to potential exposure to small parts and sharp edges, attachment, detachment,
Battery removal and any other maintenance should only be done by an adult.
ASSEMBLY
STEP 1 :
Locate the Dino Grip that is tied to the bike frame,
and cut zip tie to remove.
STEP 2 :
Unscrew the four screws in grip clamp.
STEP 3 :
Place the clamp on the handlebar and use four
WARNING: Make sure that the device is secure on the handlebar before riding or allowing you
child to ride. Failure to do so could result in a loss of control or fall.
HOW TO USE
STEP 1 :
Pull the Plastic tag from the battery cover.
PLEASE KEEP THESE INSTRUC-
TIONS FOR FUTURE REFER-
ENCE AS THEY CONTAIN
IMPORTANT INFORMATION.
4x12
screws to tighten it to the handlebar as shown.
Plastic tag
STEP 2 :
To turn on the light and make sounds,
push the button as shown.
WARNING: Do not let use of the light or
sounds features interfere with safe riding
or distract your child while riding. Never
take you hands off the handlebars while riding.
HOW TO REPLACE BATTERIES
STEP 1 :
Loosen the screw of the battery cover under
the Dino Grip.
4x12 srews
STEP 2 :
Remove the used batteries and insert
3 x 1.5V size AAA batteries as shown
in diagram at right.
STEP 3 :
Reverse above process to secure the
battery cover.
Button
Need help?
Do you have a question about the LIGHT-UP DINO GRIP and is the answer not in the manual?
Questions and answers