Communication­related Settings - Honeywell VISTA Series User Manual

The CA­FP­100Fxx FRT adopts an intelligent power management system and supports such functions as
timing power­on/shutdown and sleep timing.
1) Power On
This option is used to automatically power on the FRT at specified time. The settings of timing power­on are
similar to those of timing power­off.
2)Sleep
This option is used to set the FRT to automatically enter sleep mode at specified time. You can wake up the
FRT from sleep mode by pressing any key. The setting steps of this parameter are similar with those of timing
shutdown.
4)Idle& Idle Time
These two options are closely associated. When Idle min is 0, the Idle function is disabled. When Idle min is a
non­zero number (unit: minute), for example, 1, the system will enter a specified state if there is no operation
in 1 minute.
4.3 Communication­related Settings
Select Comm. Opt and the information displayed on the screen is shown in the following figure:
1. BaudRate
This option is used to set the baud rate for the communication between the FRT and the PC. It includes five
options: 9600, 19200, 38400, 57600, and 115200. The high baud rate is recommended for the RS232
communication to achieve high communication speed, while the low baud rate is recommended for the
RS485 communication to achieve stable low­speed communication.
2. Dev No.
This option refers to the device ID numbered from 1 to 255.
3. Net Speedê
This parameter refers to the network rate, including five options: ATUO, 10M­F, 10M­H, 100M­F and 100M­H.
"10M­F" is recommended for the ZEM100 product series and "AUTO" is recommended for the ZEM200
product series.
4. IP Addrê
The default IP address is 192.168.1.201. You can modify the IP address as required.
5. NetMaskê
The default subnet mask is 255.255.255.0. You can modify the subnet address as required.
6. Gatewayê
The default gateway is 0.0.0.0. You can modify the gateway as required.
7. Ethernetê
This parameter is used to set whether to adopt the Ethernet for communications. To adopt the Ethernet, set
this parameter to Y; otherwise set it to N.
8. RS232
Honeywell VISTA Series Products User Manual
Comm Opt
►BaudRate
Dev No.
Net Speed
IP Addr 192.168.1.201
NetMask
255.255.255.0
Gateway 192.168.1.1
Ethernet
RS232
RS485
COMM Key
17
▼
115200
1
Auto
Y
N
N
0