Advertisement
(2) License plate
mounting nuts (plugs)
Fig 13
Remove Plugs
(Fig 15) Push sensor into mounting sleeve.
Use 4mm Screws to lock sensor in place.
IMPORTANT: Sensors fit snug in sockets.
The 4mm Screws are only used to apply
slight pressure to lock the sensors in place.
Tighten both screws evenly until they touch
the sensor body only. Do not overtighten
screws or damage to sensors will result.
When it comes to quality off-road bumpers, Body Armor 4x4 is the brand you can depend on.
License plate light
(2) 6mm Screws
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
(2) 4mm Screws
ECO-SERIES REAR BUMPER 2007-2016 CHEVY
Remove screens if necessary for additional
clearance around or access to lights
Fig 14
SILVERADO\GMC SIERRA 1500
Advertisement
