Advertisement
Quick Links
Advertisement
Related Manuals for Body Armor 4x4 ECO Series
Summary of Contents for Body Armor 4x4 ECO Series
- Page 1 ECO-SERIES REAR BUMPER 2007-2017 CHEVY SILVERADO\GMC SIERRA 1500 # GM-2961...
-
Page 2: Parts List
ECO-SERIES REAR BUMPER 2007-2016 CHEVY SILVERADO\GMC SIERRA 1500 PARTS LIST: LD1 Rear Bumper Assembly 12-1.75mm x 35mm Hex Bolts Driver/left Frame Bracket 12mm x 37mm OD x 3mm Flat Washers Passenger/right Frame Bracket 12mm Nylon Lock Nuts License Plate Light 10-1.5mm x 50mm Hex Bolts License Plate Plugs 10mm x 34mm OD x 3mm Flat Washers... - Page 3 ECO-SERIES REAR BUMPER 2007-2016 CHEVY SILVERADO\GMC SIERRA 1500 d. Raise bed up slightly, only enough to clear bumper brackets. With assistance, pull bumper and brackets straight out from vehicle, (Figures 6 & 7). OPTION, 14-16 models only, bumper must be disassembled to remove to avoid raising the bed. Release the clips attaching the plastic cover to the steel bumper, (Figure 4).
- Page 4 ECO-SERIES REAR BUMPER 2007-2016 CHEVY SILVERADO\GMC SIERRA 1500 Passenger/right side installation pictured 2014-16 models, remove rear bed to frame bolts, loosen center bolts, (if equipped). Do not loosen front bolts. (Fig 1) Remove bumper bolts from outside of frame (arrows). Passenger side pictured from below WARNING! Before removing hardware, fully support the weight of the bumper with blocks or stands to prevent injury...
- Page 5 ECO-SERIES REAR BUMPER 2007-2016 CHEVY SILVERADO\GMC SIERRA 1500 Passenger/right side installation pictured WARNING! Before removing hardware, fully support the weight of the bumper with blocks or stands to prevent injury or damage to the vehicle. (Fig 5) OPTION 2014-16 only: Remove bumper bolts attaching bumper to inner bracket.
- Page 6 ECO-SERIES REAR BUMPER 2007-2016 CHEVY SILVERADO\GMC SIERRA 1500 Passenger/right side installation pictured Rear 14mm x 45mm Hex Bolt (2) 14mm Flat Washers 14mm Nylon Lock Nut (Fig 9) Attach passenger side of Bumper to frame. Model w-o receiver hitch pictured (2) 12mm x 55mm Hex Bolts (4) 12mm Flat Washers Rear...
- Page 7 Tighten both screws evenly until they touch the sensor body only. Do not overtighten screws or damage to sensors will result. When it comes to quality off-road bumpers, Body Armor 4x4 is the brand you can depend on.