Setup - Toro Groundsmaster 360 Series Operator's Manual

Setup

Media and Additional Parts
Description
Operator's Manual
Parts Catalog
WARNING
If you leave the key in the ignition switch,
someone could accidentally start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
Note:
We recommend that the appropriate adapter kit be installed prior to deck installation. The 100-inch Rear
Discharge Deck must be used in conjunction with one of the following adapter kits:
Adapter Kit, Model 31102 is used for all Groundsmaster® 360 Series 2WD Traction Units, 2013 and before
Groundsmaster® 360 Series 4WD Traction Units, and 2014 Groundsmaster® 360 Series Traction units in the
following serial ranges:
Model
31223
30536
30539
Adapter Kit, Model 31103 is for Groundsmaster® 360 Series 4WD traction units in the following serial ranges:
Model
31223
30539
All other 4WD models
Note:
Revision J or later of the Toro Diagnostic software must be installed in the vehicle controller system to
operate the deck as designed.
Qty.
1 Review the material and save it in an appropriate place.
1 Use this catalog to reference part numbers.
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
switch when the PTO shaft is not connected
to the gearbox on the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Serial range
314000101 to 314000104
314000101 to 314000105
314000101 to 314000116
Serial range
314000105 and up
314000117 and up
314000001 and up
8
Use