Adjusting The Deck-Limit Chains - Toro Groundsmaster 360 Series Operator's Manual

Adjusting the Deck-Limit
Chains
Use 2 deck shims Toro Part No. 138-8243 or 2 feeler
gauges—0.15 mm (0.060 inch)
Preparing the Deck
1. Start the engine, lower the left and right decks,
shut off the engine, remove the key, and wait for
all moving parts to stop.
2. At the outer decks, wipe clean the tab of the
inner channel (Figure
Figure 29
1. Tab (inner channel—outer
deck)
2. Front of the machine
29).
g321242
g321236
3. Back of the machine
3. At the front of the deck, fully loosen the outboard
serrated-flange nuts securing the 4 U-bolts
(Figure 30).
1. Serrated-flange nut
(inboard)
4. At the back of the deck, fully loosen the inboard
serrated-flange nuts securing the 4 U-bolts
(Figure 31).
1. U-bolt
Assembling the Shim to the Deck
1. Install the deck shims at the front of the deck
as shown in Figure
Note:
Insert the part of the long tab of the shim
under the belt cover.
22
Figure 30
2. U-bolt
Figure 31
2. Serrated-flange nut
(outboard)
32.
g321237
g321238