Toro Groundsmaster 360 Series Operator's Manual page 24

1. Inner-channel tab
2. Feeler gauge
3. Start the engine, fully raise the left and right
decks, shut off the engine, remove the key, and
wait for all moving parts to stop.
Tensioning the Chains
1. At the front of the deck, tighten the outboard
serrated-flange nuts until the chains are
tensioned (Figure
Note:
Ensure that the deck shim (or feeler
gauge) contacts then pivot link.
Important:
Ensure that the upper and lower
serrated-flange nut pairs are adjusted evenly.
Figure 34
3. Front of the machine
4. Back of the machine
35).
1. Deck shim (or feeler
gauge)
2. Serrated-flange nut
g321243
(outboard)
3. Pivot link
4. Chain (limit)
2. Thread the inboard serrated-flange nuts
35) and torque them to 103 to 127 N∙m (76 to
94 ft-lb).
3. At the back of the deck, tighten the inboard
serrated-flange nuts until the chains are
tensioned
Note:
Ensure that the deck shim (or feeler
gauge) contacts then pivot link.
Important:
serrated-flange nut pairs are adjusted evenly.
24
Figure 35
5. U-bolt
6. Front of the machine
7. Serrated-flange nut
(inboard)
(Figure 36).
Ensure that the upper and lower
g321234
(Figure