Advertisement

4 in 1 Crib
THIS PRODUCT IS NOT INTENDED FOR INSTITUTIONAL OR COMMERCIAL USE.
Consumer Care:
www.DeltaChildren.com
Delta Children's Products
114 West 26th Street
New York, NY 10001
Tele.212-645-9033
Conforms to
ASTM F1169-10a Full
Size Crib & F1821
Safety Standards
To register your product for important safety alerts and updates to your product please
visit www.DeltaChildren.com and click on Product Registration.
January 4, 2013, 21869, R3
Read all instructions before assembly and use.
KEEP INSTRUCTIONS FOR FUTURE USE.
ADULT ASSEMBLY REQUIRED
Due to the presence of small parts during assembly, keep out of
reach of children until assembly is complete.
Style #:
___________
Lot:
___________
Date:
___________
When contacting Delta Consumer Care please reference
the above information. Before contacting Delta Consumer
Care please ensure that the information above matches the
information found on the label on the Crib End bottom rail,
please reference the information found on the product
when contacting Delta Consumer Care.
A
REV
FACTORY
©2013 DELTA ENTERPRISE CORP.

Advertisement

Table of Contents
loading

Summary of Contents for Delta 7052

  • Page 1 New York, NY 10001 Tele.212-645-9033 FACTORY When contacting Delta Consumer Care please reference the above information. Before contacting Delta Consumer Care please ensure that the information above matches the information found on the label on the Crib End bottom rail,...
  • Page 2 *Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing parts, or sharp edges before and after assembly and frequently during use. Securely tighten loose bolts and Do not use crib if any parts are missing, damaged or broken. Contact Delta other fasteners.
  • Page 3 - Do not scratch or chip the finish. - Inspect the product periodically, contact delta children's products for replacement parts or questions. - Do not store the product or any parts in extreme temperatures and conditions such as a hot attic or a damp, cold basement.
  • Page 4 PARTS: MAKE SURE THAT ALL PRE-ASSEMBLED PARTS ARE TIGHT. A. Back Rail B. Front Rail F. Long Canopy Rail x2 G. Short Canopy Rail x2 D. Right Crib End C. Left Crib End H. Short Canopy J. Long Canopy Post x2 Post x2 K.
  • Page 5: Section 1: Crib Assembly

    SECTION 1: CRIB ASSEMBLY STEP 1 PARTS AND TOOLS REQUIRED TO COMPLETE STEP M4 Allen Wrench C. Left Crib End D. Right Crib End A. Back Rail M. M6x60mm Bolt x6 Attach the Left Crib End (Part C) and the Right Crib End (Part D) to the Back Rail (Part A) using (6) M6x60mm Bolts (Part M).
  • Page 6 SECTION 1: CRIB ASSEMBLY STEP 2 PARTS AND TOOLS REQUIRED TO COMPLETE STEP T. Mattress Support From Step 1 P. M6x15mm Bolt x4 WARNING Fall Hazard: When child is able to pull to a standing position or reaches a height of 35in (90cm) whichever occurs first, set mattress to lowest position and remove bumper pads, large toys and other objects that could serve as steps for climbing out.
  • Page 7 SECTION 1: CRIB ASSEMBLY STEP 3 PARTS AND TOOLS REQUIRED TO COMPLETE STEP B. Front Rail From Step 2 N. M6x40mm Bolt x6 Attach the Front Rail (Part B) to the assembly from Step 2 using (6) M6x40mm Bolts (Part N) Tighten with the M4 Allen Wrench.
  • Page 8: Section 2 Steps 1 And 2B

    SECTION 1: CRIB ASSEMBLY STEP 4 CAUTION The crib is NOT completely assembled at this point. Section 2 or Section 3 MUST be completed. Proceed to Section 3 to complete Proceed to Section 2 to complete the crib as shown above. the crib as shown above.
  • Page 9 SECTION 2: CANOPY OPTION STEP 1 PARTS AND TOOLS REQUIRED TO COMPLETE STEP H. Short Canopy J. Long Canopy From Section 1 Step 3 Post x2 Post x2 Install the Short Canopy Posts (Part H) into the back posts of the Crib. Install the Long Canopy Posts (Part J) into the Back posts of the Crib.
  • Page 10 SECTION 2: CANOPY OPTION STEP 2A PARTS AND TOOLS REQUIRED TO COMPLETE STEP F. Long Canopy Rail x2 G. Short Canopy Rail x2 K. Crystal Ball x4 Install the Canopy rails: 1. Place the Long Canopy Rails (Part F) over the bolts on top of the Canopy Posts installed in step 1.
  • Page 11 SECTION 2: CANOPY OPTION STEP 2B - Valance PARTS AND TOOLS REQUIRED TO COMPLETE STEP F. Long Canopy Rail x2 G. Short Canopy Rail x2 K. Crystal Ball x4 Long Valance Short Valance Insert the Long Canopy Rails (Part F) into the long valances. Insert The Short Canopy Rails (Part G) into the short valances.
  • Page 12: Section 3: No Canopy Option

    SECTION 3: NO CANOPY OPTION STEP 1 PARTS AND TOOLS REQUIRED TO COMPLETE STEP R. M6x15mm Large Head Bolt x4 From Section 1 Step 3 If you choose not to install the Canopy - Store all canopy parts safely, see page 3. Install (1) M6x15mm Large Head Bolt (Part R) into the top of each post.
  • Page 13 OPTIONAL CONVERSION This Crib can be converted to a toddler bed and day bed with the purchase of Delta Children’s Products Item 0085 - Toddler Bed Conversion Kit. WARNING This crib CANNOT be converted to a toddler bed or day bed without the Toddler Bed Conversion Kit.
  • Page 14: Section 4: Full Bed Conversion

    SECTION 4: Full Bed Conversion STEP 1 This crib can be converted to a Full size Bed with the purchase of Delta Children’s Products Item 0030 - Full Size Bed Rail Kit. 1. Disassemble the crib by reversing the instructions.
  • Page 15 SECTION 4: Full Bed Conversion STEP 2 Completed Full size Bed. Note: Bed rails may appear slightly different, shown for illustration only. Contact Delta Children’s Products Consumer Care with any questions.
  • Page 16: Warranty

    Delta. To register your product for important safety alerts and updates to your product please visit www.DeltaChildren.com...

Table of Contents