Logitek mixIT Setup Manual page 25

It's left over from the JetNet audio networking protocol that has been retired. EVERY input on
this page will be red, and it's perfectly okay.
Since this page is showing you what it has found from scanning the network, you'll notice there
is no "Add Input" button.
This page is important because this is where you tell the JET67 how to handle these sources
when they are routed to the console. Remember in the local IO section where you could assign
an input to a mix minus bus, associate an input with GPIO or set the mode? This is how you
connect those same features to a source that came in from the network.
Click on the line of the input you wish to edit and we'll begin.
Figure 14 - The Network Input Edit Window
Note that the Stream Name, Unique Name, Source, Type, Number of Channels, and Latency
fields are greyed out. This information is supplied by the source machine, so we can't edit those
things.
What we can do is tell the console what to do when handling this source:
GPI Inputs (valid numbers are 1-4)
Audio On – enter the GPI Input where a contact closure will turn the channel on.
Audio Off – enter the GPI Input where a contact closure will turn the channel off.
Logitek mixIT Audio Console System/JET67 Manual 25