Irradiance Measurement(Μw/Cm2 Mode); Correction Factor (C.c.f. Setting ) - Topcon UVR-300 Instruction Manual

IRRADIANCE MEASUREMENT(μW/cm2 MODE)
3.2
1
When you turn on the power, the instrument enter μW/cm
2 To enter the μW/cm
3.3
CORRECTION FACTOR (C.C.F. setting)
1
Push the [C.C.F.] switch, and the currently set C.C.F. value is displayed.
If no correction factor is registered, a set of figures "0000" is displayed and the screen
turns to the screen for numeric entry.
If a correction factor is registered, the current correction factor is displayed for 3
seconds and correction factor become effective.
If the [C.C.F.] switch is pushed again within 3 seconds, the screen turns to the same
screen for numeric entry.
Correction factor having been entered Correction factor not having been entered
Change of correction factor (C.C.F.)
1
Push the [C.C.F.] switch.
2
Entering a numerical value and pushing the [SET] switch to activate the correction
factor.
3
After displaying the correction factor for 3 seconds, the system returns to the previous
measuring mode.
22
mode from another mode, push the [μW/cm
2
Entering numerical value
2
mode automatically.
2
] switch.
☞
'3.1 NUMERIC ENTRY'