Table of Contents
Advertisement
TELE System
10 First installation
Before switching on the television, it is advisable to connect the aerial cable (terrestrial and/or satellite)
and the ethernet cable (if available). In this way, thanks to the installation wizard, you can start using your
Smart TV by performing a few simple steps briefly described below:
Step 1, Step 2, Step 3
After the welcome / start screen, the procedure requires the choice of the menu language, country of use
and time zone. Make your choices by moving the screen cursor with the ▼ arrow key on the remote
control to the desired value, then press the arrow key ► to continue.
Step 4
Section dedicated to the configuration of the TV connection to the Internet network necessary to use the
connected Smart / TV functions. If the Ethernet cable has already been connected to the TV's RJ45 port,
the connection to the home modem/router will take place automatically; otherwise, connect the Ethernet
cable and wait for the TV to connect to the network. Then go to the next step with the arrow key ► on the
remote control. If it is not possible to connect an Ethernet cable to the TV, configure the Wireless
connection using the arrow keys and ENTER on the remote control: select the item Use Wi-Fi network,
choose your own Wi-Fi network from the list of detected networks, type the correct network password
very carefully (press ENTER to bring up the virtual keyboard), then select the Connect item. Finally press
the arrow key ► to go to the next step.
Step 5
For some advanced functions, the supplied remote control does not allow full and easy use; in this regard,
there is a dedicated Android/iOS application available that will make your mobile device (smartphone or
tablet) a means to control your TV. To download the application, simply frame the QR code visible on the
screen with the appropriate QR/video camera of your mobile device, then proceed with the installation.
ATTENTION!
•
Make sure that your mobile device and Smart TV are connected to the same home data network.
•
The application does not totally replace the traditional remote control, it is mainly designed to
control the Smart features of the TV (applications, media player, etc. ...)
•
Some IP applications require the use of a keyboard and/or a cursor/mouse; in this case, the
traditional remote control supplied with the TV is not sufficient to control them.
Step 6
The last step in the configuration wizard asks you to choose the user's favorite mode / source. In
particular, by choosing TV, your product will initially start in traditional TV mode to allow the scanning and
therefore the viewing of television, terrestrial and / or satellite channels (see section 4.1). By choosing the
Home item instead, the TV will initially start in Smart TV mode to have quick access to
applications/browsers typical of a TV connected to the Internet (see section 4.4).
11 Main functions
11.1 Digital TV mode
At the end of the installation wizard (Section 3), if you have selected the TV mode, you need to scan a
digital TV channel. To access the Channel menu, set the Antenna Type between Digital Terrestrial (DVB-T /
T2), Cable (DVB-C) or Digital Satellite (DVB-S / S2), make sure that the corresponding antenna cable is
correctly connected, define the search parameters and proceed with the scan (see section 5.1).
4
Advertisement
Table of Contents
