Tele System SMART24 SLIM12V Manual page 13

TELE System
•
The TV is compatible with single universal, multi-satellite DiSEqC 1.0 and multi-user SCR/Uni-cable
systems. Motorized antennas (DiSEqC 1.2 and USALS) are not supported.
•
Incorrect antenna configuration may result in some or all channels not being loaded. If you do not
know the characteristics of your antenna system and/or you are not able to configure the receiver
yourself, it is advisable to contact a trusted professional installer.
•
The Signal and Quality Level indicators refer to the transponder of the selected satellite indicated on
the screen. Make sure that it is valid/updated and actually active.
•
It is not recommended to avoid connecting the TV to the satellite signal through the pass-through
antenna connector (LNB Out / Loop Through) of an external satellite receiver as both devices cannot
operate simultaneously. When the TV is switched on, the receiver must be in standby (with the tuner
not powered) and vice versa.
The following are the general steps to follow when setting typical antenna systems installed in Italy. In the
Channel Menu> Scan you can define the type of antenna by changing the parameter LNB type. Its possible
values are:
1. LNB Only: single satellite and single user,
2. DiSEqC: multi-satellite with DiSEqC 1.0 switch (up to 4 satellites),
3. SatCR: multi-user on a single-cable SCR / Unicable.
Single system
In the case of a classic single antenna satellite system with single universal converter (Low Noise Block -
LNB), set LNB type on LNB Only, choose the satellite to which the antenna is pointed (default HotBird 13°
East).
DiSEqC system
For multi-satellite antenna systems with signal distribution via DiSEqC 1.0 protocol (up to 4 satellites), set
DiSEqC first as LNB type, then associate the correct position through the parameters called DiSEqC
A/B/C/D to each satellite of the plant, respecting the relative physical connection of the antenna to the
DiSEqC switch.
SCR/Uni-cable system
For single-converter antenna systems with SCR/Uni-cable technology for satellite signal distribution over
multiple points of use (receivers) via a single cable, set SatCR as LNB Type and press ENTER on Position A.
Make sure the Satellite parameter carries the name of the desired satellite (otherwise change it), then
press ENTER on Satellite Configuration and define:
1. SatCR IF Channel: the user number corresponding to the SCR (or band) channel assigned to the
television connected to the antenna.
2. SatCR IF Freq.: the central frequency of the above SCR channel (band) assigned to the user. Typical
values for correct interfacing with other receivers/tuners are:
WARNINGS
•
Each TV / receiver connected to the same system must use a different SCR channel.
•
For the connection of several receivers to a SCR system, do not use any loop-through antenna
connection of an external satellite receiver, but use a dedicated external signal splitter.
12.1.2.2 Channels search
Go to the Channel> Scan menu. To run a scan on all the available transponders (frequencies) of the set
satellite(s), select Auto Scan and press ENTER. Refer also to par. 4.1 to load the default channel list.
8
Canale SCR
Freq. SCR 1210
1 2
1420
3 4
1680 2040